Ultra Shine PRO Top Coat

This PRO product is for professional use.

Preparation:
Push back the cuticles, file the nails and roughen the nail plate with the fine side of a nail file or polishing block. Degrease the nails with a Cleaner wipe. Apply the Prep Booster over the entire nail plate. Let air dry for 30 seconds.

In the next 3 steps, prevent the gel polish from coming into contact with the skin and cuticles. If necessary, use the Woodstick to clean the skin directly.

Step 1. Apply Base Coat
Apply the Base thinly. Harden the Base for 60 sec under the LED lamp.

Step 2. Apply colour
Apply 1 coat of your favourite colour. Harden each layer for 60 sec under the LED lamp. Repeat this step if necessary.

Step 3. The Finishing Touch
Apply the Ultra Shine and let it cure for 60 sec as well. This non-sticky top coat eliminates the need to remove the sticky layer from your nails after curing under the LED lamp, so you are ready to go right away!

Extra care:
Apply Cuticle Oil to your cuticles and gently massage it in.

Di-HEMA trimethylhexyl dicarbamate, Trimethylbenzoyl diphenylp- hosphine oxide, HEMA, PEG/PPG-27/27 dimethicone, Hydroxypropyl Methacrylate, p-hydroxyanisole, Hydroquinone, Ext. CI 60730.

Most of Pink Gellac's products are HEMA-free. PRO products contain HEMA and are for professional use. You can recognise these by the word PRO on the front. The following applies to these:
- avoid contact with cuticles.
- avoid skin contact.
- read instructions for use carefully.
- can cause an allergic reaction.
We offer the largest range of Pink Gellac colours without PRO-label and are therefore HEMA-free.