Press-on Nails

Preparation

Make sure your nails are shorter than the Press-ons. Gently buff the nail plate with the nail file. Then degrease the nails with a nail wipe with some cleaner. Use the Size Matcher to find the right size. Each press-on should align with your natural nail edges without overlapping. File the sides if needed for a better fit.

How to apply

With Glue Pads:

Choose the Glue Pad with the same number as the Press-on Nail and place it on your nail. Smooth out with a woodstick and then remove the film. Place the Press-on Nail at a 45° angle, press down slowly, and hold for 60 seconds.

With Nail Glue:

Apply a thin layer of glue to your natural nail and to the inside of the Press-on Nail. Place the nail at a 45° angle to the cuticle and press down firmly for 60 seconds.

How to remove

With Glue Pads:

Soak your nails in warm soapy water with cuticle oil for 10 minutes. Then, lift the press-on off with the woodstick. Remove any glue residue off the natural nail with remover and a nail wipe. To reuse, slide off the glue residue from the underside of the Press-on Nail with the woodstick.

With Nail Glue:

Soak your nails in warm soapy water with cuticle oil for 10 minutes. Then, lift the press-on off with the woodstick, add remover in between to make the removing process easier. Remove the glue residue off the natural nail with remover and a nail wipe.

Gel Nail Stickers

Application

Preparation

File your toenails into the desired shape. Cleanse your toenails with a Cleaner Pocket or a Nail Wipe with Cleaner to remove any oils. Apply the Prep Booster over the entire nail plate and let it air dry for 30 seconds. 

Step 1: Choose the right sticker

Hold the sticker sheet over your toenail and choose the sticker that fits best. Ensure the Pink Gellac logo is on the right side. Carefully remove the protective film. If you're unsure, select a sticker slightly narrower than your toenail to prevent premature lifting. Is the sticker too wide for your toenails? Trim the sides to achieve the perfect fit.

Step 2: Apply and cure

Place the sticker on your toenail and press it down firmly. Smooth the edges using the flat side of a woodstick and roll it over the sticker. Leave a 1 mm gap between the sticker and your cuticle to prevent lifting. Trim the sticker to the length of your natural nail, leaving a small edge, and cure under the LED lamp for 120 seconds.

Step 3: Finish

File the cured sticker to the desired length and shape. Smooth the edges by filing in one direction.

Optional: Apply Top Coat

For extra shine and durability, apply a thin layer of Shine Top Coat. Avoid skin contact and remove any excess with a Gel Polish Corrector Pen or woodstick before curing. Cure the Top Coat for 60 seconds under the LED lamp. Remove the sticky layer with a Cleaner Pocket or Nail Wipe, and after 1 minute, apply nourishing Cuticle Oil for added hydration.

Removal

Gently slide a woodstick under the edges of the sticker. Apply Cuticle Oil along the edges of the sticker. Slowly lift the sticker off the toenail, adding more oil under the sticker as you go to help loosen it. Repeat until the sticker is fully removed.