Preparation.
Push back the cuticles, file the nails and roughen the nail plate with the fine side of a nail file or polishing block. Degrease the nails with a Cleaner wipe. Apply the Prep Booster over the entire nail plate. Let air dry for 30 seconds.
In the next 3 steps, prevent the gel polish from coming into contact with the skin and cuticles. If necessary, use the Woodstick to clean the skin directly.
Before curing, make sure your nails are well positioned under the lamp and that the LED rays reach your nails sufficiently. It is important that your nails do not stick out from under it. Cure your thumbs separately for the best result.
Step 1. Apply Base Coat
Apply the Peel Base over the entire nail plate. Allow to air dry for 30 seconds.
Optional: Apply the normal Base thinly for extra strength. Harden the Base for 60 sec under the LED lamp.
Step 2. Apply colour
Apply 1 layer of your favourite colour. Harden each layer for 60 sec under the LED lamp. Repeat this step if necessary.
Step 3. The Finishing Touch
Apply the Top Coat and let it cure for 60 sec as well. After this, wait 2 minutes and then remove the sticky layer with a cleaning cloth. After that, you're ready to go!
Extra care.
Apply Cuticle Oil to your cuticles and gently massage it in.
Fancy a new gel polish colour?
The Pink Gellac Peel Base is easy to peel off the nails. Gently try to peel off a piece of the gellac. Now you can easily peel the gel polish off the nail. You are immediately ready to apply a new colour!
